Atomizer Aerosol Generator TOPAS Model ATM 228
Air flow rate: 20 … 250 l/h
Mass flow rate: 0 … 1,4 g/h
continuously adjustable
Particle production rate:
4,0×1006 … 1,4×1010 #/s
continuously adjustable
Aerosol substances:
DEHS, PAO (Emery 3004), paraffin oil, salt solutions, suspensions (PSL, A1)
The ATM 228 is a further development of the highly sucsessful ATM 226 aerosol generator and fully complies with the requirements of VDI 3491-2.
According to ISO 14644-3 this device can be used to test the filter integrity of HEPA and ULPA filters as well as measuring the recovery time. It can also be used in the test of very small filter cross sections where very low aerosol quantities are required. The ATM 228 has been developed for particularly stable aerosol generation at low nozzle volume flows or nozzle pressures.
The advantage of the generator lies in a very wide adjustable concentration range with highest aerosol stability. Thus an optical cleanroom particle counter can be operated directly on the ATM228 without dilution system below the coincidence limit.
Specifications
Air flow rate: 20 … 250 l/h
Mass flow rate: 0 … 1,4 g/h
continuously adjustable
Particle production rate:
4,0×1006 … 1,4×1010 #/s
continuously adjustable
Aerosol substances:
DEHS, PAO (Emery 3004), paraffin oil, salt solutions, suspensions (PSL, A1)
Substance capacity: 20 … 80 ml
Non-stop operation: > 44 h
Non-stop operation battery : ≤ 10 h (optional)
Counterpressure: max. 40 kPa
Aerosol outlet: hose fitting ∅ 8 mm
Power supply: 100 … 240 VAC, 12 VDC
Air supply: compressor
Dimensions:
(w x h x d): 300 x 120 x 195 mm
Weight: 3,9 kg
Accessories
. Carry case for one dilution system DIL and one aerosol generator.
You may also like…
-
Photometer ATI Model TDA 2i
. Hepa Filter Testing ISO 14644-3.
. Lightweight, portable and rugged digital photometer
Large.
. 4.3″ LCD screen to display critical information.
. iProbe (optional) with 12 ft cable for hard to reach areas minimizes downtime.
. User settable aerosol noise suppression for more stable aerosol measurements.
. Printer (optional) available for reporting. -
Aerosol Diluter ATI – TDA D10 / TDA D100
. Compatible with any 1 cfm particle counter.
. Minimizes pressure drops and aerosol loss.
. Available in 10:1 and 100:1 dilution ratio configurations.
. Can be plumbed in series for alternate dilution configurations.
. Ideal for isolators, mask fittings and installation with low airflows.
. Works with any type of aerosol challenge, including PSL, PAO, DOP, and NaCl.
Related products
-
Smoke generator MICRORITE
- . Visualization and monitoring of airflow (ISO 14644-3 Annex B7) in classified environments.
- . Pressure balancing between rooms (visual indication).
- . Optimization of equipment location.
- . Discovery of unsuspected sources of particulate and gaseous contamination.
- . Monitoring air infiltration paths to minimize the introduction of particles into critical areas.
